Check category

What are the main technical indicators of the tact switch?

  • Categories:Company News
  • Author:
  • Origin:
  • Time of issue:2019-03-20 10:19
  • Views:

(Summary description)Tactile Switch When the manufacturer introduces the terminal for soldering, if the load is applied to the terminal

What are the main technical indicators of the tact switch?

(Summary description)Tactile Switch When the manufacturer introduces the terminal for soldering, if the load is applied to the terminal

  • Categories:Company News
  • Author:
  • Origin:
  • Time of issue:2019-03-20 10:19
  • Views:
Information

1. Tactile Switch When the manufacturer introduces the terminal for soldering, if the load is applied to the terminal, it may be loose due to different conditions. It may cause deformation and deterioration of electrical characteristics. Please pay attention when using the switch.

 

2. The effects of thermal stress may change when using through-hole printed circuit boards and other recommended boards. Therefore, the welding conditions are fully confirmed in advance.

 

3. After welding twice, return to normal temperature after the first welding. Continued heating may deform the peripheral portion, loosen, drop terminals, and deteriorate electrical characteristics.

 

4. Under the set welding conditions, the actual mass production conditions need to be confirmed.

 

5. This product is based on the premise of DC resistance load design and manufacturing. When using other loads [inductive load (L), capacitive load? ], please check separately.

 

6. For PCB mounting holes and patterns, please refer to the recommended dimensions recorded on the product drawings.

 

7. This switch is applied to the direct operation of the personnel switch structure. Please do not use it for mechanical inspection. Please use our sensor switch.

 

8. Switch operation, if the specified load is applied, the switch will be damaged. Be careful not to apply the specified force to the switch.

 

9. Please avoid using the operating parts on the side.

 

10. Tact switch manufacturer analysis, for the flat axis type, try to press the switch center. For the hinge structure, the axial pressure position will move when pressed, so please pay special attention.

Scan the QR code to read on your phone